It makes a lot of sense to install a bidet spray in a washroom basin as it is very useful. It offers better hygiene than toilet paper and is easy to fix on the toilet. The bidet spray can be installed quickly, and any previously installed spray can be replaced with ease and a few tools.
This article by https://www.plumbersingapore.org/ provides instructions on how to install and replace a bidet spray. You can do it quickly if you are willing to devote some time and effort.
Tools You Need
A list of such items to provide before beginning the work includes the following:
- A new bidet spray set
- Adjustable wrench or pliers
- Teflon tape (plumber’s tape)
- A small bucket or towel (if there is any spilling of water during the cooking process)
Installing a New Bidet Spray
Step 1: The water supply to the toilet should be turned off.
It is often a circular device found beneath the toilet’s base or near the pipeline. Rotate it anti-clockwise until water ceases to flow through the pipe.
Step 2: Disconnect the Water Hose
It is recommended to put a plastic bucket or a towel under this connection to avoid spillage of any remnant water. Turn the hose clockwise, which is lined with a wrench, and it can be unscrewed from the inlet at the toilet tank.
Step 3: Attach the T-Valve
Disengage the T-valve of the bidet spray set and screw it onto the water supply outlet. Use pressure but not excessively because it may be risky to overdo it. The T-valve is mounted at the bottom of the wall to provide water to the toilet tank and the bidet spray.
Step 4: Connect the Hoses
One end of the toilet hose should be connected to the T-valve at the top part, and the other end should be connected to the bottom of the toilet tank. Then, a bidet hose should be connected to the side port of the T-valve. Ensure that the two connections are well-tightened so there will be no leakage.
Step 5：Open Up the Water
Gradually open the water supply valve, and let the water slowly diminish until it stops. Here, one should look at the leaks around the connections. If any of these are loose, slight tightening or applying Teflon tape will improve the seal.
Step 6: Test the Bidet Spray
Press the bidet spray trigger to ensure that the water pressure is not too strong. If necessary, learn how to regulate the T-bar by turning the T-valve to shift into idle. When all the elements and functions of the bidet spray are operational, your bidet spray is fit for use!
Replacing an Old Bidet Spray
In the case of bidet spray replacement of a damaged or leaking bidet spray, these are the steps to follow:
Step 1: Shut off the water supply from the source
The water supply to the toilet should be controlled, and sometimes, this requires turning off the water valve close to the toilet.
Step 2: Refitting:
The old bidet spray should be removed so that the new one can be installed. To do this, one needs to take a wrench and remove the bidet hose from what is referred to as the T-valve. If the T-valve is old or leaking, it should be replaced. As always, when working on hoses, the marks that should no longer be present on the fittings should not be visible after the completion of the repair process.
Step 3: Install New Bidet Spray
You have to actually place the new bidet spray inside the restroom or shower enclosure where it will be used. You can click here if you want it done professionally at https://www.plumbersingapore.org/bidet-spray-installation-replacement/.
The next step is to connect the new bidet hose to the T-valve. If you are changing the T-valve, you should follow the installation procedures mentioned above.
Step 4: Check for Leaks
Connect the supply and verify all connections. If there is leakage, check all joints and use sealant or Teflon tape to solve the problem.
Step 5: Test the new bidet spray
Pulling the trigger also ensures that the water pressure is okay and everything is in order.